First 22-D keystone firing

The first pressed 22D is dry, so she is stuck down at the bottom of the kiln where she fits nicely and also an inch away from the kiln walls. I decided the best position to fire these is flat on their backs rather than standing upright on their tops where the center webbing and the bottom could possibly sag downwards a bit from gravity when the clay gets soft from the heat. I can fit two of these in laid flat.
So to do that I can use 5 of my nice tall posts to support the octagon shelf which in turn supports the 2nd sculpture. The 7 small posts laid flat on the shelf are there to raise the sculpture up off the shelf so heat and air can circulate inside it while at the same time supporting it well and evenly all around it’s back so it won’t likely warp.
I was going to put the 2nd beaver panel in with the one 22D but they won’t fit together with 22D laid flat, so now I have to change gears and press another 22D but using the remaining red clay I have which should be JUST enough, and that will be about 3 weeks before that one is dry enough to fire. So it’s going to be about 3 weeks wait until I can do another load.

All the posts and shelf, shelves since I have several half octagons as well- are called “kiln furniture” so a different meaning for an old word most people never knew!
This kiln came with a nice selection of included furniture in the package- a variety of posts, shelves, and wired stilts used under glazed pieces.